|
How to operate your foam machine
Important Note: During operation, the foam machine must have fluid available and pumping through the tube at all times. Running the machine "dry" will destroy the pump instantly!
Before plugging your unit in, fill the fluid container with Foam or Snow Fluid from StarLight.com. The fluid container should hold about a gallon and half.
CAUTION: RUNNING FOAM MACHINE WITHOUT FLUID WILL IMMEDIATELY DESTROY THE PUMP.
Make Sure that the tube is stuck down into the fluid reservoir so that the end of the tube is at the bottom of the fluid container. If it is near the top, the machine will not get fluid and the pump will be damaged.
 
Plug one end of the power cord into the foam machine, and the other end into a standard wall outlet. The foam machine pulls 9 amps, so a you cannot put more than two on a circuit without tripping a breaker.
Turn the power on at the rear of the foam machine.
Clean your foam machine regularly by running about
1/2 cup of warm water through the machine. This can be done by
dropping the tube into a cup of warm water and turning the machine
on as if making foam. This should be done before storing the
foam machine for any length of time. This will prevent the foam
fluid from becoming solid in the line or pump and stopping up
the machine.
Click here for MSDS
Thanks,
and Happy Foaming!
|
